top of page
10X 30mm Square Base Adaptor Socket for GW Square 25mm

10X 30mm Square Base Adaptor Socket for GW Square 25mm

SKU: 103DPS25_30

10 Bases 30 mm Square Base Adaptor Socket for GW Square 25 mm version 22_12 Using Black PLA
Perfect for skirmishers!

Those adaptors are specially made for old figurines to be playable for the old world.  It's guaranteed compatible with the GW 2001 25mm bases that are precisely 24.7mm. This design accepts a layer of paint on the base. If the bottom of your base is larger than 24.8mm then it might be going to be too tight or won't fit.
A smaller base will work until it's too small. Unsure? Order one sample before ordering many.
Please let me know if you have a ''25mm'' GW base of another year that is not 24.7mm, I will make the insert a little larger to accommodate.

This special adaptor has been designed for a few reasons:
-To avoid rebasing your figurines and risking damaging them.
-To avoid seams between the figurine's base and the adaptor.
-For the adaptor to be properly attached to the figurine's base without needing magnets or glue.
-So when you grab your skirmishers the adaptor doesn't fall or stay on the ground. 

Logo Signature LM of designer @laurentmaynardvisualart

-When removing the lock, pull the left and right in the same time as much as possible to avoid breaking the lock bits. You can use your fingernails or blade on sides of the lock. Same thing when you put it back in, push it parallel flat. 
-Make sure the edges of your figurine's bases are clean and don't have grass for example, paint is ok. 

-Make sure the insert is free of dust and paint before inserting your figurine. Same thing for the lock. 
-After your figurine is inserted, make sure it's fully inserted before putting the lock.
-You can paint the base with the figurine inserted but it's safer to apply glue for grass with the figurine NOT inserted otherwise it might get stuck. Make sure the insert part is clear before putting the figurine back. 
-Once everything painted with grass and stuff on it, after removing the lock, if you struggle to remove your figurine. You can either use a pointy thing like the other tip of a brush and push from underneath. You can also put your figurine on table and with a knife, point at the front of  your figurine's base and push forward. 

I know they are as many rules as in Warhammer's rules book, which makes those bases more authentic! ahah
I hope you like the seamless result and how easy it is to move your skirmishers around! :) 

Let me know if you have any problems or even suggestions here.

  • Returns & exchanges not accepted

  • More accurate shipping fees/time can be requested

    You can send email or fill up contact form to get more  accurate Est. delivery time and refund if shipping ended up cheaper. 

bottom of page